Summary
Most sensor faults come from dirt, a knock that changes the aim, or something new in the detection zone. Staff can clean and check; adjusting safety sensors is a job for a trained engineer.
An automatic door usually has two kinds of sensor. One tells it to open when someone approaches. The other keeps it from closing on, or hitting, someone in its path. The first is about convenience. The second is about safety, and it is the reason the law asks for powered doors to have features that stop them trapping people (Workplace Regulations, regulation 18).
The door will not open for anyone
- Check the programme switch. Someone may have set it to “closed” or “exit only”.
- Check the power and the isolator, and whether there has been a power cut.
- Wipe the sensor cover with a dry, soft cloth. A film of dust or grease is enough to blind some sensors.
- Look for a new obstruction: a sign, a stand or a mat that has changed what the sensor sees.
If none of that works, it may be the sensor itself, its wiring or the control board. That needs an engineer.
The door opens for nobody
This is the classic sliding door fault. The sensor is picking up movement it should ignore: a swinging sign, plants, rain, traffic on the pavement, or reflections on a shiny floor. Moving or removing the cause often fixes it. If the sensor has been knocked, its aim needs resetting, and that is an engineer’s job.
The door closes on people, or nearly does
Stop using the door automatically. Switch it to open or off, keep the opening clear and call it in. A safety sensor that misses people is the fault that causes injuries, and it should not wait for the next planned visit.
Staff jobs and engineer jobs
Cleaning, clearing the area and checking switches are fine. Adjusting sensor angles, sensitivity or safety settings is not: they are set and tested against the safety standard by a trained engineer, and a wrong adjustment can leave a gap in protection. CIBSE describes daily checks of the safety devices and a weekly check by the occupier, with formal inspections left to engineers.
Stopping it happening again
Sensors are checked and cleaned on every planned visit. If faults keep coming back, ask the engineer whether the sensor type suits the entrance. Our automatic door repair page covers other common faults, and planned maintenance explains what each visit checks. If you need a firm, our automatic door servicing form will find one near the site.
